Newest Version 6CH Walkera #76A-1 CCPM 3D Aerobatic Radio Remote Control Electric RC Helicopter RTF

The Newest Design Walkera #76A-1 (Belt Driven). The latest version of the outstanding Walkera 76 Series RC helicopter. Now fitted with belt driven tail rotor system and an all new lower mainframe design which includes upgraded skid/struts and battery holder.

Walkera 76A DragonFly

The Walkera #76A-1 retains the tried and tested components that made the original so reliable and rewarding to fly. In addition to the new structural improvements and belt drive, Walkera have modified the tail setup to give even more responsive control.

Walkera 76A DragonFly

This is probably the best ready-to-fly helicopter you can buy... and this is definitely the place to buy it!

Walkera 76A DragonFly

All of the major components are preassembled The 120-degree CCPM head design uses 3 servos to control the collective pitch and the cyclic controls. Once you master hovering and slow circuits in "Normal" mode, switch into "Idle Up 1" mode and Honey Bee King II’s high-performance motor has plenty of power for sport flying and inverted flight. The tailboom is machined for perfect 90-degree alignment of the tail rotor to the main rotor without adjustments.

Walkera 76A DragonFly

6 Channel R/C Set included, complete Forward/Backward, Left/Right, Up/Down & Pitch Control (RUDDER, AILERON, ELEVATOR, Pitch AND THROTTLE)
New 6 channel Transmitter with PIT and PLT mode lock switch and adjustable knob
Improved blades give superior lift. Their pop off design gives extra protection in case of heavy landing
Perfect for people who wants to move up from 4ch helicopter
Perfect for intermediate pilots or pilots who want to try inverted fly or 3D aerobatic flight
CCPM mixing control system and collective pitch structure make perfect 3D maneuvers such as roll, inverted, and swoop flights
120 degree CCPM system provides precise movement if comparing with the traditional mechanical mixing since there are less linkage/push-rod in the helicopter and weight is greatly reduced
Bell-heller mixing greatly increase the sensitive of the whole helicopter, which provide good aerobatic responds
O-ring inside the center hub reduce oscillation of main blades
Powerful 370 super carbon brush motor used as the main drive and makes the flight much stable
The autorotation landing system, made of high quality one-way bearing, maximally protects your helicopter from damage
Hard, Light weight Main Blades
Brand new design for the structure
Improved battery support that holds the battery firmly, and can also be adjusted to suit your balance of flying
Tail rotor driven by belt provide stable flight and low noise
NO TAIL Motor - Tail Rotor driven by Belt with Servo Controlled Rudder like Gas-Helicopter
No need to worry about burning tail motors
Light and hardened blades provide great lift, only weight 11g
Outer placed gyro
With length-adjustable servo push-rod, precision sub trim can be easily set
Approximately 5 - 8 minutes flight time on each charge
Best choice for Beginner - Advanced hobbyist
Complete Kit, Ready to Fly (Everything is included and 100% assembled -- only required 8 AA batteries for the transmitter to start flying)

Specification:

Main Rotor Diameter: 550 mm
Tail Rotor Diameter: 122 mm
Overall Length: 550 mm
Receiver: RX- PCM-701
Drive System: 370 SH
Battery: Ni-MH 10.8V 650mAh
All-up Weight: 467g (Battery included)
Transmitter: WK-PCM-0701
Gyro: WK-G012
Speed Controller: WTS-20A-02
Servo: weight 8.5g ; speed 0.11sec/60o; torque 0.9kg/cm ; dimension 22.5X11.5X24mm