450 Helicopter D2830 3500rpm/v 438W Outrunner Brushless Motor w/ 11T/13T Pinion Gear |
The Raiden 2830 3500KV brushless outrunner motor is designed for 450 size RC
helicopters and truely an excellent upgrade for Align T-Rex 450 SE/XL/SE
V2/Pro, Blawk Hawk 450, Blade 400, EXI 450, Blue Ray 450 plus many similar
size helicopters. You will need an ESC comparable of 30A/40A (sold
seperately) for this setup.
|
Specification: |
| rpm/v (kv) :
|
D2830-3500 |
| Airplane Class : |
600g (450 EP
Helicopter) |
| Suggested Battery : |
11.1v Lipo Battery
|
| No Load Current : |
3.7A |
| No Load Speed (rpm) : |
39000 |
| Load Current (A) : |
20A/7.4v |
| Load Speed (rpm) : |
21700 |
| Recommended ESC : |
30A
ESC or 40A ESC |
| Suggested Propellers : |
APC7X4 |
| Pull(g) : |
440 |
| Weight : |
~52g |
| Packaging Weight : |
~100g |
|
Configure
Advise and Usage Limit: |
| 1. |
Advise
application power 250W |
| 2. |
Momentary power
400W max |
| 3. |
Propose configure for this
motor:
- Battery---1800mAh 20C
3Slipo
- ESC---30A
- propeller--- APC7X4
|
| 4. |
Don't let the
exiguous carbon steel metal too close with motor when fixing, it breathe inside
motor by magnetic field then cause the motor to set up or cause the winding
short! |
| 5. |
Please use
stainless steel screws when fixing the motor, and the length of the screw don′t
longer than the pedestal, lest to breach the wire! |
| 6. |
Motor temperature
should not exceed 90℃ |
|
Configuration
characteristic: |
| 1. |
Magnet---N35SH |
| 2. |
Silicon
steel---0.2(mm) |
| 3. |
Bearing---NMB |
| 4. |
Shaft--- Carbon
steel |
| 5. |
Guide wind
system--- Free cooling |
| 6. |
Insulated
material--- Somar Epoxy (Japan) |
|
Reliability
Testing: |
| 1. |
Testing Condition
- Voltage---11.1(V)
- Propeller--- GWS1047
- Load
current---14.5(A)
- Net Thrust---850(g)
- Room temperature---25(℃)
- Run mode---5 Minute ON, 2
Minute OFF
- Shaft direction gap---
0.05-0.2mm
- Noise no load---30db
|
| 2. |
After testing 100 times
circle
- Net thrust---800(g)
- Current---13(A)
- Temperature rising---85(℃)
- Shaft direction gap---
0.1-0.2mm
- Run mode---5 Minute ON, 2
Minute OFF
|
|
Item(s) Included:
|
|
450 Helicopter 3500rpm/v 438W Outrunner Brushless Motor |
|
Gold
Connectors |
|
11T, 13T Motor Gears |
|
Screws |
|
Shrink Plastic
Tubes | |
