Specification(T-REX 600E PRO DFC) :
1.Equipped with the low CG DFC rotor head, effectively reduce wind resistance during flight, providing the most direct and precise control feel back to the pilot, and exhibits exhilarating 3D performance and unimaginable flight speed.
2.The frame utilizes 2mm carbon fiber plates of the highest spec. Patented composite material construction technique cleverly utilize frame space that improved overall rigidity, and also created a minimalistic beauty.
3.Innovative sliding battery tray rails imbedded into the 3K side frames, with patented spring loaded latching mechanism, allowing for quick battery access as well as battery protection.
4.Heatsink embedded into motor mount for effective cooling of motor.
5.Top mounted motor base bringing the motor’s center of gravity closer to rotating disc, improving 3D agility.
6.Utilize direct link CCPM swashplate control system to enable direct and fast control response. Specially designed anodized CNC servo horns are not only visually pleasing, but are extremely rigid.
7.Utilizes highest spec CNC modue-1 helical main gear, with highest load tolerance and lowest noise.
8.The most optimal motor pinion ratio and tail gear ratio to achieve the most efficient power output and flight characteristic.
9.High quality 5mm carbon rod and CNC metal tail scissor control arms are used in rudder control system to improve rudder lockingand control effectiveness.
10.Additional radial bearing is added to the one way bearing block to ensure smooth rotation, and eliminate jammed one way bearing.
11.Brand new 600 class 12S high voltage brushless motor providing generous torque and power output, yet consumes lower average current to prolong the life of batteries
12.Motor mount consists of third bearing block to provide motor shaft support, effectively reduce torque induced shifts, and minimize gear striping issue.
13.High quality new tail gearbox design, combined with new dual point mounted tail pitch control assembly to minimize slops and increase rudder control precision.
14.Brand new CNC machined metal tail gear box, with thicker side plates to increase rigidity. The more streamlined design also allows for simpler disassembly.
15.Total pitch range of +15~-15 degrees, for the ultimate 3D explosive power.
16.Tail pitch mechanism equipped with high precision bearing.
17.High speed thrust bearings in tail blade grips.
18.New lightened landing gear assembly with lower center of gravity.
19.High quality painted fiberglass canopy with 4-point quick release mounts.

Users must have a certain concept of security to operate the R/C helicopters.
Be sure to read and comply with related safety notes of instruction manual before flying.

Specification(T-REX 600E PRO DFC):

Length: 1174mm

Height: 319mm

Width: 210mm

Main Blade Length: 600mm

Main Rotor Diameter: 1347mm

Tail Rotor Diameter: 260mm

Motor Drive Gear:13T

Main Drive Gear:112T

Autorotation Tail Drive Gear: 131T

Tail Drive Gear: 34T

Drive Gear Ratio: 1:8.61:3.85

Weight(With Motor): 2290g

Accessories:

T-REX 600E PRO DFC Kits Set X1

600 3G Carbon fiber blades X1

600MX Brushless Motor(510KV) X1

DS615 Standard servo X3

DS655 Specialized servo X1

Castle ICE2 HV 80 Brushless ESC X1

6A External BEC w/ 5.1V Two-way Step-down voltage regulator X1

Radio transmitter and electronic equipment required for assembly:

Transmitter(7-channel or more, helicopter system)

Receiver(7-channel or more)

6S Li-Po 2600 ~ 4600mAh X2 (3300mAh suggestion)

Dial Pitch Gauge or Digital Pitch Gauge

3GX Flybarless System X1